 |
||
| CHARGE CONTROLLERS | ||
|
Morningstar Tristar Charge
Controller
Tristar Data Sheet Tristar Operators Manual
Tristar Digital Meter - Controller Based or Remote
 |
Tristar TS-60 Solar/Turbine Charge Controllers For use in Battery-Based systems, these rugged charge controllers offer protection against overcharging when used with our solar panels or wind turbines. The Tristar is capable of handling charging currents of 60A, and is suitable for use with battery banks of 12/24 and 48Volts. In order to use these controllers with your Turbine and Battery Bank, you will require a suitable dump load for connection to the TS-60. These dump loads are shown below, and can be bought separately if required. We can also supply 48v Standard 2.25" BSP Direct Replacement 1KW Immersion Heaters for £64.99 for use with our turbines. If you are purchasing a Miniwind 2200 Turbine, we recommend that you have 2 TS-60s in Parallel if your turbine is wired for 24v and likely to be subject to high winds. One TS-60 is recommended for the 48v version unless it would be subject to extreme weather. If in doubt - double up..... The Miniwinds can produce in excess of 100 amps at 24v. The following number of dump loads are required with each of the following battery voltages.
Optional Extras Tristar Meter TS-M and TS-M Remote Key Features and BenefitsThe meter will display a great deal of information about the TriStar controller and the operation of your system. In addition, the meter enables manual functions and controller diagnostics. These capabilities will increase your confidence that the system is working properly and will help you to improve system reliability, battery life, and system performance. It is worth the time getting to know your meter!The TS-M Remote is a self contained meter with 30m of cable to allow you to monitor the Controller at a distance (you can have both!) |
|
|
|
Xantrex C40 & C60 Charge Controllers For use in Battery-Based systems, these rugged charge controllers offer protection against overcharging when used with our wind turbines. The Xantrex C60 is capable of handling charging currents of 60A, and is suitable for use with battery banks of 12V and 24V only. The C40 can handle charging currents of up to 40A, and is suitable for use in 48V battery charging applications which use our turbines. In order to use either of these controllers with your Turbine and Battery Bank, you will require a suitable dump load for connection to the C40 or C60. These dump loads are shown under Dump Loads, and can be bought separately if required. The following number of dump loads are required with each of the following battery voltages.
|
|
